Drawer Slides Standard

Attach the Drawer Slides to the Ends of the cabinet before assembling the cabinet.

1. Screw on the Drawer Slides to the pre-drilled holes, using the Euro Screws -2 screws per drawer.
Note: These must go in the oblong holes that are made in the Drawer Slides. When screwing these up, aim to have the screw in the centre of the hole.

2. The smaller screws (5x15mm) are the 'locking' screws, but these are not used at the assembly stage. These are used after the cabinets have been levelled and installed. The Drawer Slides may need to be slightly adjusted (i.e: the front of the Slide needs to be raised a little and the rear of the Drawer Slide needs to be tapped down a little), so that the drawer Fronts end up sitting nice and flat against the carcass. It's only after this adjustment has been made (and the drawer runs through a final adjustment check and it all looks good), that you screw in these locking screws. Once these screws are screwed in, it locks the Drawer Slide in position.