Wardrobe Internal Drawers

 

A Drawer Unit comes complete with all screws and hardware required to assemble and they are inserted into the Wardrobe Internal, between the two blades. 
Note: In your order you will find the paperwork on your job (A4 sheets of paper) and in there is a detailed Assembly Instruction sheet which tells you 'Which screw attaches to what and how many'. 

 

Assembly process:

1. Attach the Drawer Slides to the Ends (Gables).  Click the button below to show you how it's done:


2. Attach the Back Bench top Connector.  Click the button below to show you how it's done:

 
3. Join the Bottom (base) to a cabinet End (also known as a 'Gable' in some areas of Australia). Use the correct screw as identified in the detailed Assembly Instruction sheet (normally a 50mm screw). The joints are all butt joins as the screws act as a steel dowel, securing the pieces together.
Note: A Machined location hole is drilled into the bottom front section of the End itself and this is to identify the bottom of the End front of the part. Make sure that when fixing the End to the Bottom, this is at the Bottom.
 
 
 

4. Join the remaining End (Gable) to the Bottom (Base) of the Cabinet. Note: The image below has a sink bowl cut out in it, as this was a Special request from the customer, so yours wil not have this. 



 

5. Attach the Back. Use the correct scew as identified in the detailed Assembly Instruction sheet (normally a 50mm screw).
Tip: Double check that the back is affixed the correct way up. It is a common mistake to put the back upside down and if the Back has adjustable shelf holes in it, then these will not line up correctly when the shelf is installed.
 
 
 
6. Fix the Rail (Stretcher) to both the Cabinet Ends (Gables). Use the correct screw as identified in the detailed Assembly Instruction sheet (normally a 50mm screw, but this can vary).
Tip: A good idea is to pre-drill the rails with a 3mm drill bit to avoid the rail ‘splitting’.
 
 
 
 
 
7. Assemble the Drawer Runners. Here is how to do these:
 

 

8. Attach Door Fronts to Cabinet. Here is how to do these:
 

 


 

We hope that this information has been helpful for you.

If you need further help or more information on this topic please: 

 


Thank you, 
From all the team at OzFlatPacks