Drawer Runners - Push to Open

 

1. Lay out the Drawer Bottom and the Drawer Rear.
Note: See this image: The Drawer Rear is now attached to the Drawer Bottom with CAM Fittings (rather than screws) to make the assembly easier.
Note: Make sure that you do not install this updside down - You can see that the Drawer Runner holes are at the bottom of the Drawer Bottom. An easy way to check this is to ensure that both the part's labels are to the outside of the Drawer Runner and NOT on the inside!
Note: The Drawer Back is set in around 7mm to both sides of the Drawer Bottom (it is not flush with the drawer bottom). 

 

IMPORTANT NOTE: The cam holes are drilled from the bottom of the drawer bottom. They are designed to drill all the way through so that they pop out of the top face. The drill hole is designed to drill through by a marginal amount of just 0.2mm, however in some cases it may appear that the drill bit has not gone all the way through. So when you view the top of the drawer bottom, it may appear that it has not gone all the way through. You should find that simply pressing with your finger where the drill has not gone 100% through, will open up the hole so that you can insert the cam fitting correctly on the top face. 
Once assembled, your drawer back and drawer base should look like the image below (with the drawer runner attachment holes on the bottom face):

 

 

2. To attach the metal Drawer runners to the drawer bottom and rear, click here: 

3. To attach the drawer front to the drawer, click here: